At XRUN, quality control is integrated throughout the manufacturing process, from raw material preparation to final inspection and shipment.
For titanium sheet, plate, coil, strip and bar products, inspection activities are performed at multiple stages to verify chemical composition, mechanical properties, dimensions and surface quality according to applicable standards and customer requirements.
Raw Material Control
Quality begins with the control of raw materials used in production.
Before entering the manufacturing process, raw materials are verified to ensure compliance with production specifications and traceability requirements.
Key controls include:
- Raw material identification
- Batch traceability records
- Material composition verification
- Production documentation review
In-Process Quality Control
Inspection is conducted during production to monitor critical manufacturing parameters and product consistency.
Depending on the product type and customer requirements, in-process controls may include:
For Titanium Bar
- Billet inspection
- Forging process monitoring
- Dimensional verification
- Surface condition inspection
For Titanium Sheet & Plate
- Thickness measurement
- Width and length verification
- Flatness inspection
- Surface quality inspection
For Titanium Coil & Strip
- Thickness consistency monitoring
- Width control
- Edge condition inspection
- Coil identification and traceability
Final Product Inspection
Before shipment, finished products undergo final inspection according to production specifications and applicable standards.
Inspection items may include:
Chemical Composition Analysis
Verification of alloy composition to ensure compliance with material specifications.
Mechanical Property Testing
Testing may include:
- Tensile Strength
- Yield Strength
- Elongation
- Additional tests when required
Dimensional Inspection
Verification of:
- Thickness
- Width
- Length
- Diameter
- Straightness
- Flatness
Surface Inspection
Visual and dimensional evaluation of surface condition, finish quality and product appearance.
Non-Destructive Testing
Additional inspection methods can be performed according to customer specifications.
Available testing options may include:
Ultrasonic Testing (UT)
Surface Defect Inspection
Additional non-destructive examinations upon request
Material Traceability
Each production batch is assigned identification records throughout manufacturing.
Traceability records may include:
- Raw material batch information
- Production batch numbers
- Inspection records
- Product identification markings
This system allows production and inspection data to be linked to specific material lots.
Documentation Available
Inspection and quality documentation can be supplied with shipments when required.
Available documents may include:
Mill Test Certificate (MTC)
Chemical Analysis Report
Mechanical Test Report
Dimensional Inspection Report
Ultrasonic Testing Report
Packing List
Certificate of Origin
Third-Party Inspection Report
Third-Party Inspection
Independent inspection can be arranged according to customer requirements.
Third-party inspection services may include:
- Product verification
- Witness testing
- Documentation review
- Pre-shipment inspection
Inspection scope is determined based on project specifications and contractual requirements.
Products Covered by Our Quality Control System
The quality control process applies to:
Products can be supplied according to customer specifications, international standards and project-specific requirements.
Titanium Sheet
1
>>
Titanium Plate
2
>>
Titanium Coil
3
>>
Titanium Strip
4
>>
Titanium Bar
5
Discuss Your Quality Requirements
If your project requires specific testing procedures, documentation packages or inspection standards, our team can review the requirements during quotation and production planning.
Contact us to discuss material specifications and quality documentation requirements.